Description
This parking sensor hole cutter tool set provides a precise and clean way to cut holes for installing parking assist sensors on replacement bumpers.
It is designed to punch a hole in the bumper without damaging the paintwork.
This method gives a much better finish than using a hole saw.
It will cut holes in plastic bumpers up to 5mm thick.
The set includes a range of cutter sizes and push plates, a drive bolt and a HSS-G twist drill.
Simply select the correct cutters and plate for the required hole size, drill a guide hole, assemble the cutter and use a ratchet or wrench to tighten the drive bolt and cut the hole.
Key Features:
- Precise and clean way to cut holes for parking sensors
- Designed to punch through bumpers without damaging paintwork
- Gives a better finish than using a hole saw
- Will cut plastic bumpers up to 5mm thick
- Simple design, operated with a ratchet or wrench
Contents:
- Cutter sizes for the following hole diameters: 17mm, 18mm, 18.2mm, 19mm, 20mm, 22.5mm, 24mm, 26mm, 26.7mm and 32mm
- 8mm HSS-G twist drill
- Drive bolt
- Push plates
- Supplied in a storage case
Reviews
There are no reviews yet.